Mosaic Stepping Stone Instructions
Step 1: Waterproof a Swimming Pool
Step 2: Prepare the surface 
Step 3: Prepare:
         + Tools: trowel, gluing table, tape measure, straight ruler, container, glue machine, ...
         + Check the surface clean, check the flatness with straight rulers as Vietnam standard with measurement error ± 0.5 mm.
     Concrete walls, plaster walls ≥ 75.

     Cleaning the wall and floor surfaces

     Moisten the wall by spraying water.

     Mixing glue with water (A mount of water about 18-22% compared with the amount of glue). Mix the glue evenly into a homogeneous mixture, without clumping. Time is about 7-10 minutes

  Step4:  Spread glue:
  Spread 2 - 3mm thick glue on the wall and floor surface
   Create flat, create adhesion surface by serrated table.
  Step 5: Mosaic tiles:
 Locate the wall according to the size of the tile edge with wire positioned from left to right from top to bottom.
Paste the face mosaic blister with mesh paste onto the flat glue.
Hand holding two corners of the paste and ke mosaic mosaic in a straight line with the above.
Use a clean baffle table to gently pull on the tile surface in a criss-cross pattern and make sure the members stick to the glue surface.

  Step 6. Vein and clean (Perform after pasting Mosaic on 04 hour adhesive):

          Wipe the surface before spreading

        - Mixing glue with clean water (water ratio of 28-30% compared with glue)

        - Use plastic plastic scraper to squeeze the glue circuit into the adhesive glue circuit to fill the circuit joints. glue for swimming